Design For Monitoring Current And Voltage In Battery Charger Using NodeMCU Esp8266 Microcontroller And The Blynk Appdi Silampari Airport Lubuk Linggau–South Sumatra

Muhammad Caesar Akbar; Mikael Angripa Saragih

Authors

Muhammad Caesar Akbar Medan Aviation Polytechnic, Medan, North Sumatera, Indonesia
Mikael Angripa Saragih Medan Aviation Polytechnic, Medan, North Sumatera, Indonesia

Keywords:

Current and Voltage Monitoring, Bylnk, NodeMCU microcontroller ESP8266

Abstract

At Silampari Airport there are frequent power outages not only 1 to 2 times a day and even experienced up to 4 blackouts. During the second blackout on the same day, the 550 kVA generator failed to start due to a voltage drop in the generator battery. This condition could result in disruption of the operational system at Silampari Airport.. Dbecause Silampari airport does not have a spare battery, so the voltage and current values of the battery must be detected, so that the generator does not fail to start. To monitor the battery and to find out the value of the battery input voltage, battery power and remaining battery power, a voltage and current monitoring design for the 550 generator battery charger is required. Kva.Presearch This method uses descriptive analysis and a qualitative approach. The result of this research is that a control system for regulating voltage and load current using NodeMCU ESP8266 based on the Internet of Things with the Bylnk platform has been realized. The design of the tool has been realized as a tool for monitoring battery charger voltage and current using the IoT concept by utilizing the main components, namely the voltage sensor, ACS712 current sensor, NodeMCU data processor equipped with an IoT module in the form of ESP8266.

Downloads

Download data is not yet available.

References

Akbar, MC, & Legian, AP (2022, December). Troubleshooting Strobe Light Not Blinking on ATR 72-500 at Batam Aero Technic. Airman Journal of Transportation Engineering and Safety, 6(1), 1-7. doi: https://doi.org/10.46509/ajtk.v6i1.248

Akbar, MC, & Mulyana, RP (2023, June). Added Procedures and Requirements for Aircraft Making a Circling Approach to Runway 35 in the SOP of Sultan Iskandar Muda International Airport. Airman Journal of Transportation Engineering and Safety, 6(1), 1-7. doi:10.46509/ajtk.v6i1.229

Akbar, MC, & Simamora, C. (2022, December). Blank Area Analysis of MSSR Radar Beam at Airnav Tanjungpinang Due to Obstacles Obstructing Radar Beam. AIRMAN Journal of Transportation Engineering and Safety, 5(2), 12-21. doi:10.46509/ajtk.v5i2.252

Akbar, MC, & Sinaga, BH (2022, December). Analysis of the causes of non-delivery of Cengkareng (CKG)3 Radar Data from the Jakarta Air Traffic Service Center (JATSC) to AirNav Halim Perdanakusuma Branch. AIRMAN Journal of Transportation Engineering and Safety, 5(3), 46-53. doi:10.46509/ajtk.v5i2.253

Akbar, MC, Saputra, ST, & Sonhaji, I. (2022, December). IMPLEMENTATION OF PUSHBACK PROCEDURE AND TAXI ROUTING AT THE CARGO APRON OF KUALANAMU DELISERDANG INTERNATIONAL AIRPORT. Surabaya Aviation Polytechnic Research Journal, 7(4), 264-272.

Andre Wahyudi Sihombing, MC (2022, September). A MACH AIRSPEED WARNING SYSTEM IN COCKPIT. Surabaya Aviation Polytechnic Research Journal, 7 (3), 224-234.

Ardiansyah, (2022). "swift house temperature control and control system based on intelligent technology", computer science study program,.

F. fjuandi, (2011) "Introduction to Arduino", E-book, tobuku.

Hanifah Kusumastuti, Endryansyah, Nur Kholis, (2022) "Design of a portable PLTS to supply mobile chargers based on the internet of things", Indonesian Journal of Engineering and Technology (Inajet).

Hutasoit, NA, & Akbar, MC (2022, September). Replacement of Rotating Beacon at Adi Soemarmo Solo International Airport. Surabaya Aviation Polytechnic Research Journal, 7(3), 216-223.

JUnaldy, Muhammad Junaldy, et al, (2019). "Design of a current and voltage monitoring device for an Arduino-based solar panel system"¸Journal of Electrical and Computer Engineering.

Lusita, Dewi Nurul hidayati, Mimin F. Rohmah, Soffa Zahara, (2019) "smart home prototype with ESP8266 nodemcu module", Mahapahit Islamic University Inforamtics Engineering Student

Pangestu, Ella putri niga, Zainul arifin imam supardi, (2020). "Study of the charge-discharge process in Pb-PbO2 batteries". Indonesian Physics Innovation Journal.

Pasaribu, SA, & Akbar, MC (2022, September). Modification of the Driver Module on the Precission Approach Lighting System (PALS) lights at Sultan Syarif Kasim II Airport Pekanbaru. Surabaya Aviation Polytechnic Research Journal, 7 (03), 257-263.

Pranodo Diky, Afif Ridho Akbar, (2021). "Care and maintenance system for generator set 501-B at PT Titis Sampurna LPG Plant Limau Timur PrabuElect." Putra Academic Engineering Journal.

Rosman Andi, et al, (2019). "Characteristics of current and voltage in series and parallel circuits using resistors". Scientific journal d'Computare.

Suteja, Wayan Arsa Suteja, Adi Surya Antara, (2021)," analysis of invasive current sensors

ACS712 and non-invasive current sensor SCT013 based on Arduino".

Wowu Andrianto, Mimin F. Rohman, Sugianto, (2019). "Light control system using Android-based Arduino", Faculty of Engineering, Majapahit Islamic University.

Wicaksono, Mochamad Fajar, (2017), "Implementation of the ESP11 nodemcu wifi module for smart home", Unikom computer engineering journal.

Wijaya, NMA, et al, (2021). "Development of batteries and chargers to support electric bicycle society in Indonesia", SPEKTRUM Journal.